Schedulers

Overview of the different schedulers (or 'run modes') in Murex

There are a few distinct schedulers (or run modes) in Murex which are invoked by builtin commands. This means you can alter the way commands are executed dynamically within Murex shell scripts.

Normal

This is a traditional shell where anything in a pipeline (eg cmd1 -> cmd2 -> cmd3) is executed in parallel. The scheduler only pauses launching new commands when the last command in any pipeline is still executing. A pipeline could be multiple commands (like above) or a single command (eg top).

Normal is the default run mode. When running in a stricter mode, you can not reset the run mode back to normal. You can, however, switch to unsafe.

Unsafe

This is the same as normal except that unsafe blocks always return zero exit numbers. The purpose for this is to enable "normal" like scheduling inside stricter code blocks that might exit if the last function was a non-zero exit number.

Try

This is the weakest of all the stricter run modes. It does check the exit number to confirm if the last function was successful, but only the last function in any given pipeline. So in cmd1 -> cmd2 -> cmd3, if cmd1 or cmd2 fail, the try block doesn't exit.

The benefit of run mode is that it still supports commands running in parallel.

Try Pipe

This runs the commands sequentially because the stderr and the exit number of each command is checked irrespective of whether that command is at the start of the pipeline (eg start -> middle -> end), or anywhere else.

This offers better coverage of exit numbers but at the cost of parallelisation.

Try Err

This is similar to try and normal where commands in a pipeline are run in parallel. The key difference with tryerr is that Murex validates the stderr as well as the exit number of the last command in any pipeline.

If stderr is greater than stdout (per bytes written) OR the exit number is non-zero then the scheduler exits that entire block.

Try Pipe Err

This runs the commands sequentially because the stderr and the exit number of each command is checked irrespective of whether that command is at the start of the pipeline (eg start -> middle -> end), or anywhere else.

Like with tryerr, if stderr is greater than stdout (per bytes written) OR the exit number is non-zero then the scheduler exits that entire block. Unlike with tryerr, this check happens on every command rather than the last command in the pipeline.

See Also

• Disable Error Handling In Block (unsafe): Execute a block of code, always returning a zero exit number
• Function / Module Defaults (runmode): Alter the scheduler's behaviour at higher scoping level
• Pipe Fail (trypipe): Checks for non-zero exits of each function in a pipeline
• Pipeline: Overview of what a "pipeline" is
• Stderr Checking In Pipes (trypipeerr): Checks state of each function in a pipeline and exits block on error
• Stderr Checking In TTY (tryerr): Handles errors inside a block of code
• Try Block (try): Handles non-zero exits inside a block of code
• -> Arrow Pipe: Pipes stdout from the left hand command to stdin of the right hand command
• => Generic Pipe: Pipes a reformatted stdout stream from the left hand command to stdin of the right hand command
• ? stderr Pipe: Pipes stderr from the left hand command to stdin of the right hand command (DEPRECATED)
• | POSIX Pipe: Pipes stdout from the left hand command to stdin of the right hand command

---

This document was generated from gen/user-guide/schedulers_doc.yaml.